For ASO Safety Solutions SENTIR edge Safety Edges for Gates Replacement | SENTIR edge 35.85 CT
- Model
- SENTIR edge | SENTIR edge 35.85 CT
Item specifics
- Series:
- SENTIR edge
- Sensor length:
- Max. 6 or 25 m
- Actuation distance:
- 4.6 mm
- Actuation force:
- 37.7 N
- Response time:
- —
- Cross-sectional area:
- 36 mm × 85 mm
- Material:
- TPE
- Degree of protection:
- IP65
- Certifications:
- TÜV, UL
Review
Description
For ASO Safety Solutions SENTIR edge Safety Edges for Gates Replacement Parameter
Brand | From network | DADISICK |
||
Models | SENTIR edge 35.85 CT |
DB-PSE-360 | ||
Detection method | — | Pressure-sensitive | ||
Sensor length | Max. 6 or 25 m | 200 mm to 6000 mm | ||
Actuation distance | 4.6 mm | < 5 mm | ||
Actuation force | 37.7 N | ≤ 100 N | ||
Overtravel distance | 60.6 mm (400 N) | < 45 mm | ||
Response time | — | 13 ms | ||
Cross-sectional area | Width: 35 mm, Height: 85 mm | Width: 35 mm, Height: 60 mm (base not included, base height: 14 mm) | ||
Maximum operation angle | 2 × 45° | < 90° | ||
Material | TPE | EPDM | ||
Degree of protection | IP65 | IP65 | ||
Connection | Max. 6 or 25 meters PUR LIY11Y 2 × 0.34 mm² | 2 meters VVR Ø 4 mm 2 × 0.35 mm² (Red/black core) | ||
Certifications | TÜV, UL | TÜV | ||
Mechanical life | — | > 3,000,000 times | ||
Ambient operating temperature | -10℃ to 50℃ | -20℃ to 55℃ | ||
We are able to reproduce the specific connection configuration of each brand with high level of accuracy. |
Product model display instructions
The brands and specifications shown on this page are for product selection only. Our safety edges is a safety part made by DADISICK, not official brand ASO Safety Solutions's products. DAIDSICK offer replacement for official brand products. We are not the owner of the brands. If you need to buy official brand products, please contact the brand official representative.
Product recommendations
DB-PSE series safety edges
DB-PSE Series Satety Edges Dimensions
DB-PSE Series Satety Edges Cross-sectional area
DB-PSE Series Satety Edges's Base dimensions
FAQ
How are Pressure Sensitive Safety Edges installed?
Installation involves mounting the safety edge along the edge of the moving part where protection is needed. It is then connected to a control unit or safety relay, which monitors the edge and triggers a response when pressure is detected.
Disclaimers
The product model information provided on this website is sourced from public channels, aiming to provide users with reference for product comparison and selection. This website does not guarantee the accuracy, completeness, or reliability of information, nor does it constitute a recommendation or recognition of any brand or company. Users should verify and bear corresponding risks when using the information provided on this website. This website shall not be liable for any loss or damage caused by the use of information on this website.